Ajax

Thanks Oberkc, Quick question with doing 2 programs just for turning lights on and off, how many programs total do most guys run? I mean I know it is going to vary, but it seems I am going to spend days just creating the most basic functions

Wiki would be great with the updated info, I need to update my LS programming as well.

So I did use a device (Garage Exterior) to check if the scene "Exterior Lights" are one-Is that the correct way to check? I will remove the "Status" Since yes in theory what's it going to do just turn in on. But how would I have done that if I did want to check a status first? Since mine looks very similar to the one below but does not work Thanks guys

Yes not sure why but for some reason I could not select a scene for status so I just used one of the devices (Garage Exterior) that is in a 3-way scene (Exterior Lights). If I leave the else statement blank and the lights were turned on my before the program triggered will it still shut off the lights at 11:30 or do I write another program?

Guys not sure what I am doing wrong but why would this program make my lights flash instead of running? Exterior Lights - [iD 0003][Parent 0001][Not Enabled] If From Sunset + 30 minutes To 11:30:00PM (same day) And Status 'Garage Exterior' is Off Then Set Scene 'Exterior Lights' On Else Set Scene 'Exterior Lights' Off

Has anyone tried these? http://rayshobby.net/

Well I tried something I should have tried first, tried logging in from another network and it works just fine...Must be something with my network at work that does not allow it. Too bad I was really looking forward to wasting my time at work to write some programs. But it did pop up a message about my certificate is unsafe etc, and send me to the Network security Manual. But is that just for the Pro? I have the 994i with Z-wave. Should I be doing anything different regarding the security setup? Thanks

What do you mean no secure port? Something like port 80? If that is the case it says its closed

I tried using that tool earlier but for some reason it would not let me enter(change) the IP but found another one (yougetsignal) and it says that it is open.

Thanks for the fast reply-Sorry I might not have posted it correctly but I am using the one that I use to access my router from outside my network WAN. The same one that I use for the Ctrlhome app.

Ok guys long time lurker, first time poster- finally got my system up and going. One major issue at this moment is that I cannot seem to access my Admin console from outside my network. I am running a Netgear R7800 router that has Unpnp but for some reason did not work when I tried to set my ISY for remote access. But I just went ahead and port forwarded port 443 and reserved the IP. I can use the App CtrlHome on my Iphone and access my ISY remotely on my desktop, but when I select admin console it goes there, shows the screen and then times out. So I figured I had to install the applet. I also cleared everything in the Java cache. So I installed the one that matches my firmware 4.5.1. Which brings up the ISY finder but I have tried https://myIp http://myip https://myip:443 http://myip:443 But keeps saying not found, what am I missing? Thanks

Check the switches as well, I picked up a bunch today for $25 a piece with combined shipping of $7 dont look for the PRIME ones they are higher priced.

Would love it!