PapaBear

I did a power cycle in my ISY and the lights sequenced according to the link you referenced. My PLM was plugged in with a green light prior to power cycle of ISY. Attached are screen shots from MobiLinc X and ISY network info.

After updating ISY994i to 5.3.4 successfully I did a power cycle on comcast modem and ISY. Now my isy says DICONNECTED. What did I do wrong to get into this mess?

MrBill, Thanks for the tip. You were right, not at all intuitive.

I am trying to change the ramp rate and on level of a LampLinc (B2457D2). See attached clip for UI info.

Thanks but I have already cleared the Java cache twice. I tried hitting the tab key after making a change but still it doesn't update.

I successfully upgraded my ISY 944i to 5.3.4. I can control devices from the UDI admin console but when I change device settings and hit write changes nothing happens. What am I doing wrong?

Got it. Thank you.

I am running v 4.9.0 on an ISY994i. I only use Insteon devices and have about 50 of them. I use lots of scenes but only have just a few basic programs. Should I upgrade my ISY firmware? If yes, which version should I upgrade to. Thanks for the advice.

Can anyone point me to advice on upgrading? I see that various 5.x versions are in Beta. I assume that 5.x is needed to use the new motion sensors.

I have a keypad linc dimmer (2486D, 6 button, v39) that I can't get a button programmed on. The ISY says it has successfully added the button to a scene but the button doesn't turn on the in-line switch it was linked too in the scene.

Thanks for the responses. Very helpful. I have a switchlinc on the circuit already so I will probably try that first. Does anyone have a recommendation for a good source for LED strips and transformers on-line?

I want to install LED lighting strips above cabinets. The dimable transformers are very expensive. Can I use an insteon device to dim the 12 volt side?