nfaries Posted January 26, 2014 Posted January 26, 2014 I have a new 2334-2 dual band 8 button keypadlinc which will not work properly. I have several other keypadlincs but this is the first dual band one and it's driving me crazy. I have a scene for "all master bedroom lights" which includes a fanlinc light, a switchlinc for the closet and a switchlinc with no load. I have all of the responders added to the scene, and the two switchlincs, and all works fine. I add the A button from the keypadlinc as another controller, and again all is fine. BUT when I add the keypadlinc buttons for the closet and fanlinc light as responders, the A button on the keypadlinc stops responding. I've tried every combination of adding and removing keypadlinc buttons and everything works until I add the A button as a controller. As a responder it works fine, with the closet and fanlinc buttons as responders, they work fine. Even if I turn the scene on from the ISY, the status on the buttons shows ON including the A button, but the one A button doesn't turn on.
Michel Kohanim Posted January 26, 2014 Posted January 26, 2014 Hi nfaries, Please remove from ISY, do a factory reset on it, and then add it back. Any improvements? With kind regards, Michel
nfaries Posted January 26, 2014 Author Posted January 26, 2014 I have removed it and re-added. No change. How do I do a factory reset?
EricK Posted January 26, 2014 Posted January 26, 2014 I copied this from the product users guide. I slide a small screw driver underneath the set button to pull it out. Then use the screw driver to push and hold in the set button. It can take a couple of tries to do the reset. Sometimes the switch plate can get in the way so taking it off first can help. Factory Reset clears all user settings from Keypad including INSTEON scenes, on-levels, ramp rates, X10 addresses, etc. 1) With a small screwdriver or your fingernail, pull out Set button to create an air gap 2) Wait 10 seconds 3) Push in Set button and hold. Do not let go Keypad will begin to emit a long beep 4) When the beep stops, release the Set button. Device’s embedded software will rewrite all settings to factory defaults A couple of seconds will pass Keypad will double-beep and its LEDs will return to normal brightness The connected load will turn on and Keypad will return to ready mode Eric
Brian H Posted January 26, 2014 Posted January 26, 2014 If you don't have the Full Users Manual it is here: http://www.smarthome.com/manuals/2334-2xx.pdf
nfaries Posted January 26, 2014 Author Posted January 26, 2014 Aha, at first I thought it wasn't working - the ISY showed the status as on but the button LEDs were still off like before. I checked the LED brightness though, and the levels were set to 0,0 (I'd seen this happen before, but it wasn't the previous problem), so I set it to 7,15, and it is now working perfectly! Thanks guys, that's a new one for me and a great fix..
Recommended Posts