Bernman Posted March 8, 2014 Share Posted March 8, 2014 I have an ADT Pulse alarm which I would like to integrate with my ISY. The ISY can have a Z-wave module, but so far I have not been able to find any info on how to interface to the Pulse, so I didn't buy the module yet. Does anyone have interface information, or know if/when this info might be available, either from ADT (seems unlikely) or from "non-official" sources? I know that I could switch to ELK and the interface is built in to the ISY, but replacement is not practical at this point. The minimum info I would like to have is ARMED - AWAY, but other sensor states would be really nice too. Link to comment
txNgineer Posted March 9, 2014 Share Posted March 9, 2014 I don't know if it will help, but typically ADT is a reseller of either GE Simon or Honeywell systems. The one I saw was a GE Simon 4. You might be able to get more specific info from googling that rather than ADT Pulse. Hope this helps. Link to comment
fbelg210 Posted March 11, 2014 Share Posted March 11, 2014 Bernman, From what I have been researching, you need 2 pieces to the puzzle. The Module, which I purchased, and the other is a hardware upgrade which I didn't get until I find out if this will really work. Frank Link to comment
Recommended Posts