TheWabit Posted December 28, 2015 Posted December 28, 2015 Got my Fanlinc all setup. When selecting high on the fan motor through the admin console, it turns like it is on low. I believe I selected high before I started the transition (it is possible I pulled the chain the wrong number of times). And if I didn't set it right to begin with, how do I fix it? Thanks
apostolakisl Posted December 28, 2015 Posted December 28, 2015 (edited) Turn the fanlinc on high, then pull the string on the fan until it goes to full speed. Edited December 28, 2015 by apostolakisl
TheWabit Posted December 28, 2015 Author Posted December 28, 2015 Sorry - I should have said that - I tried that first and it didn't change.
TheWabit Posted December 28, 2015 Author Posted December 28, 2015 Disregard - I figured it out. Too embarrassed to tell what I did wrong.
fryfrog Posted December 30, 2015 Posted December 30, 2015 Disregard - I figured it out. Too embarrassed to tell what I did wrong. Please tell, it could help someone in the future... and give us all a good chuckle!
TheWabit Posted December 30, 2015 Author Posted December 30, 2015 Ha! I was pulling the wrong (light) chain instead of the fan chain! Dangit
Recommended Posts