Jump to content

Z-Wave Plus


Brandon

Recommended Posts

What is the current status of Z-Wave Plus support on the ISY-994iZw controllers? <-Doesn't exist

 

Is Z-Wave Plus supported? <- No

 

Is it fully supported and if not, what is and is not supported? Gen 5 specifications will outline what you will miss.

 

If it is not supported, what is the road map for adding this support? <- No ETA

 

In line . . .

Link to comment

Let's wait until regular Z-Wave is well supported before we start asking for Z-Wave Plus. Also I believe at least the Z-Wave module would have to be replaced.

 

Sent from my SM-N910W8 using Tapatalk

What is not well supported about the existing Z-Wave module?

There are several threads already discussing this.

 

Short and to the point.

Best regards,

Gary Funk

I assumed there would be but i was not able to quickly find them. Can you direct me to them?

Link to comment

What is not well supported about the existing Z-Wave module?

 

I assumed there would be but i was not able to quickly find them. Can you direct me to them?

Not without spending time searching. I don't keep track, I just read every post that comes up each day. But i can tell you it was after August 6th.

 

Best regards,

Gary Funk

Link to comment
  • 4 months later...

Not without spending time searching. I don't keep track, I just read every post that comes up each day. But i can tell you it was after August 6th.

 

Best regards,

Gary Funk

 

Do you know off hand if these issues are going to be solved by the update? Or if they are even being taken into account?
 
And at the risk of sounding like I don't know anything, is the Z-Wave plus not the same as the next official Z-Wave release?
Link to comment

 

Do you know off hand if these issues are going to be solved by the update? Or if they are even being taken into account?
 
And at the risk of sounding like I don't know anything, is the Z-Wave plus not the same as the next official Z-Wave release?

 

 

My understanding is that Z-Wave plus is the same as Z-Wave Gen 5.

Link to comment
  • 8 months later...
  • 1 year later...

Any chance there's a Z-Wave Plus module coming?  Can I replace the module in my existing Z-Wave if it was ordered with Z-Wave installed?  Including and Excluding is the absolute worst right now.  Dealing with door locks having to come all the way to the hub makes me want to not use any of it.

Link to comment

It's been out and as long as you run firmware 5.0.13 and above you can swap.

Due to the nature of locks, you'll still need to bring them close to the isy to add anyway. Adding your lock prior to installation would make that process much easier.

If done properly, this should be a one time process. What problems are you having that makes you have to do it on a regular basis?

Link to comment

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...