Jump to content
View in the app

A better way to browse. Learn more.
Universal Devices Forum

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Motion Sensor 2842-222 v.24 Low Bat

JCBond
in ISY994

Featured Replies

Posted

I have several Motion Sensors 2842-222 v.24 and I have noticed that whenever the Low Bat status turns on. I can't reset it back to off even though I have replaced the battery.

 

The only way I have found so far that works is to delete the sensor and re-add it again to the system.

 

Has anyone else seen this issue? Is there something I am not doing that I should?

After replacing the battery, set the MS to linking mode and query it. Another solution is to use a program to update the sensor:

 

IN Front Hall Sensor
If
        Control 'IN / Devices / IN Front Hall-Sensor' is switched On
 
Then
        Set 'IN / Devices / IN Front Hall-Sensor' Write Device Updates
 
Else
   - No Actions - (To add one, press 'Action')
 
I actually have the program disabled (to save the battery) and I run [THEN] when needed.

MS units are not capable of sending LowBatt Off, only On.

 

UDI has created a workaround by faking the Off in ISY. See Michel's post above.

Edited by larryllix

Guest
This topic is now closed to further replies.
Go to topic listing

Configure browser push notifications
Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.