Wildstar Posted October 8, 2017 Posted October 8, 2017 I am trying to do a simple program - when I turn on a fan, I want a program to turn it off 10 minutes later. I have tried using both STATUS and the CONTROL in the IF statement, and neither are triggering when I change the switch state. This said - when I manually hit the switch, the state does not change on the ISY Admin Control Panel - however, I can control the switch from the ISY Admin Control Panel. I noticed, none of my manual changes at the switch locations are changing the state of the ISY Admin Control Panel. I am assuming if I can get the status commands from the switches to either be sent, or recognized by the ISY Admin Control Panel, then the program will run. Any ideas on how to do this are appreciated! Thanks
Michel Kohanim Posted October 8, 2017 Posted October 8, 2017 Wildstar, Please check : http://wiki.universal-devices.com/index.php?title=INSTEON_No_Status_Feedback_From_Devices With kind regards, Michel
MrBill Posted October 8, 2017 Posted October 8, 2017 (edited) I do this with my attic fan. Attic Fan 4hr timer - [ID 003B][Parent 0001] If Control 'MBR Bedside1 / Attic Fan 4 Hr' is switched On Or Control 'MBR Bedside2 / Attic Fan 4 hr' is switched On Then Wait 4 hours Set Scene 'Attic Fan' Off Else - No Actions - (To add one, press 'Action') The actual attic fan switch is a 2477S that is not listed in the program. The two controls listed are buttons on a 8-button keypads. All 3 devices are 'Controllers' for an attic fan scene. Pushing the button on the KPL actually turns on the scene AND triggers the program that turns the scene back off. If the attic fan is activated by the 2477S that is actually switching the load, the timing program will NOT be triggered and the attic fan will stay on until turned off manually from any of the 3 locations. Edited October 8, 2017 by MrBill
oberkc Posted October 8, 2017 Posted October 8, 2017 Clearly the admin panel should be showing accurate status. If not, programs won’t work. Whether you have link record issues or communication interference, this needs to be identified and corrected. If the steps in the linked wiki article does not solve the problem, you should begin troubleshooting potential sources of interference.
Brian H Posted October 8, 2017 Posted October 8, 2017 (edited) How old is the PLM? The 2413S PLM has a reputation to have a failed power supply. Usually over the two year old service time. Post the results from the tests Michel linked to. Edited October 8, 2017 by Brian H
Wildstar Posted October 9, 2017 Author Posted October 9, 2017 The PLM is a brand new 2413S rev 2.3. The PLM has 63 links (did a restore) and the ISY still does not report the status. I can control just fine, but I can't see any user changes at the switch level.
oberkc Posted October 9, 2017 Posted October 9, 2017 Then I would look at communication issues. In the outlet and circuit that powers the PLM, are there lots of other electronic devices, such as computers, modems, printers, UPS, power supplies? Have you confirmed communication between the legs of your electrical system?
Recommended Posts