stillen_i30 Posted August 22, 2018 Share Posted August 22, 2018 I have Trane XL 824 thermostats and I'm trying to include these in my ISY system. A post a while back said this was not possible. I disconnected it from the Nexia bridge and tried to include the thermostat to no avail. -Every time I try to enter Learn Mode to have the thermostat "shifted" to the ISY, the ISY AC crashes. Even if I don't set the thermostat into shift mode, the AC will crash if I enter learn mode. Firmware 5.0.13C -Both of my Zwave locks have now disappeared from my console suddenly after doing this. How do I get these back? Restoring a prior backup did not resolve the issue (now it does show the locks with a red ! next to them but no communication with them Link to comment
lilyoyo1 Posted August 22, 2018 Share Posted August 22, 2018 I dont think the trane can be added as it's a hub by itself. It allows you to add zwave devices and control those. I believe trane has it locked to the nexia line. Link to comment
stillen_i30 Posted August 22, 2018 Author Share Posted August 22, 2018 9 hours ago, lilyoyo1 said: I dont think the trane can be added as it's a hub by itself. It allows you to add zwave devices and control those. I believe trane has it locked to the nexia line. damn, thanks for confirming this. I will stop trying to add it, effectively stopping me from messing up the rest of my z-wave devices. Any idea why my locks disappeared and when I restored an old backup, the locks now show up but have the red !? I excluded one and re-added, but had to redo all of the scenes and programs with it. Left the other one as it is in case there was an easier solution (new to z-wave commands). Tried rebuilding the links but that didn't do anything Link to comment
lilyoyo1 Posted August 23, 2018 Share Posted August 23, 2018 If the synchronize nodes doesn't work then I'd remove and then re-add. I don't know why they disappeared. Maybe the prices of adding another controller erased the links. I've never experienced that. Link to comment
stillen_i30 Posted August 24, 2018 Author Share Posted August 24, 2018 As followup, I never was able to remove all three nodes that were stagnant and errored. I ran synchronize and two of the nodes were removed and the third still remains as a duplicate (of my repeater) but hasn't caused any issues and no longer has a red "!" so I left it alone Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.