TriLife Posted August 15, 2020 Share Posted August 15, 2020 Greetings; I have a newbie question: Trying to control outputs 7-16 of the ELK M1. On ISY, it only shows 65 and up. I did figure out to tick the SHOW box in ELK RP, but I haven't figured out how to "sync" the newly available outputs. And, yes, I did disconnect ELK RP from the panel. Cheers. JR Link to comment Share on other sites More sharing options...
garybixler Posted August 15, 2020 Share Posted August 15, 2020 Have you tried going to 'Configuration-Elk-Configuration' and do a Refresh Topology? Link to comment Share on other sites More sharing options...
TriLife Posted August 17, 2020 Author Share Posted August 17, 2020 On 8/15/2020 at 5:47 PM, garybixler said: Have you tried going to 'Configuration-Elk-Configuration' and do a Refresh Topology? That worked, thanks Gary! Link to comment Share on other sites More sharing options...
CMcCarron Posted March 16, 2021 Share Posted March 16, 2021 I wonder if there are any other troubleshooting steps for this condition that anyone can suggest? I just added the Elk module to my ISY and no matter what I do I can only get outputs 065 - 208. I've tried to refresh it and it doesn't really help. The module is communicating - I can see that when I trip a zone the status changes immediately at the ISY. But no matter what I seem to do, including reboots and refreshes, I can't get the outputs below 065 to show up. Any ideas appreciated! Link to comment Share on other sites More sharing options...
CMcCarron Posted March 16, 2021 Share Posted March 16, 2021 Disregard that please - apparently still had ElkRP connected so the refresh silently fails. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.