Posted September 11, 20205 yr I have a Zooz Z-Wave Plus S2 Outdoor Motion Sensor ZSE29, 2 Aeotec Range Extender 6's, and my ISY994i with Z-wave. When motion is detected, it comes On in my Admin Console view but stays on for several minutes even though there is no motion. Sometimes I can go trigger the motion again (see the red light) and then in a few seconds, it will go to Off. That seeems like it's missing a change to Off on the first motion detect. Could that be? Ideas to make this more reliable?
September 11, 20205 yr @Kentinada, Most probably a parameter that you must set on the MS. Unfortunately I don't know which one. With kind regards, Michel
September 11, 20205 yr 27 minutes ago, Kentinada said: I have a Zooz Z-Wave Plus S2 Outdoor Motion Sensor ZSE29, 2 Aeotec Range Extender 6's, and my ISY994i with Z-wave. When motion is detected, it comes On in my Admin Console view but stays on for several minutes even though there is no motion. Sometimes I can go trigger the motion again (see the red light) and then in a few seconds, it will go to Off. That seeems like it's missing a change to Off on the first motion detect. Could that be? Ideas to make this more reliable? I had the same issue with a GE sensor and resolved this by lowering the sensor's sensitivity.
September 12, 20205 yr Temporarily bring the sensor closer to the isy. Heal your network and test. If it becomes more reliable it may be a range issue
Archived
This topic is now archived and is closed to further replies.