Z-wave Motion Sensor stays On

[Kentinada]

I have a Zooz Z-Wave Plus S2 Outdoor Motion Sensor ZSE29, 2 Aeotec Range Extender 6's, and my ISY994i with Z-wave.  When motion is detected, it comes On in my Admin Console view but stays on for several minutes even though there is no motion.  Sometimes I can go trigger the motion again (see the red light) and then in a few seconds, it will go to Off. That seeems like it's missing a change to Off on the first motion detect.  Could that be?  Ideas to make this more reliable?

[Michel Kohanim]

@Kentinada,

Most probably a parameter that you must set on the MS. Unfortunately I don't know which one.

With kind regards,
Michel

[asbril]

27 minutes ago, Kentinada said:

I have a Zooz Z-Wave Plus S2 Outdoor Motion Sensor ZSE29, 2 Aeotec Range Extender 6's, and my ISY994i with Z-wave.  When motion is detected, it comes On in my Admin Console view but stays on for several minutes even though there is no motion.  Sometimes I can go trigger the motion again (see the red light) and then in a few seconds, it will go to Off. That seeems like it's missing a change to Off on the first motion detect.  Could that be?  Ideas to make this more reliable?

I had the same issue with a GE sensor and resolved this by lowering the sensor's sensitivity.

[lilyoyo1]

Temporarily bring the sensor closer to the isy. Heal your network and test. If it becomes more reliable it may be a range issue