I just added my first Z-Wave device on the Polisy ISY being the ZooZ Multirelay ZEN16. I am trying to separate the relays from the switch inputs so they can be used to indicate weather the garage door is open or closed. I have done that with customized parameters. Also I believe that the Basic Control 2 node should be able to read the state of the switch. ON/OFF.  The Z-Wave options shows a setting for button press detection which I added to the node. ISY does see the change but is not reflected in that node.  Not sure if this can be done. Just looking for any info or suggestions. Just in experimental mode at this time.

Thanks Gary

Update: I found that the ZEN17 may be better suited for what I am trying to do. Will give that a shot.

 

 

 

 

Edited December 12, 20213 yr by garybixler

I have a Zen17 and was able to separate the outputs from the sensors. I had to set a couple parameters and then remove/add the switch again.

Edited January 12, 20223 yr by brians