Harmony Responding to Status; Doesnt Control

[pjjameso]

Just setting up Harmony Elite with the Node server.  I am able to see my switches on the harmony remote and they are correctly indicating the status when switched on and off in the ISY.  However they are not able to control the switches directly, almost like the command is not been sent. Is the Hue Port 8080 suppose to be the same as the ISY 8080?

2022-04-23 11:42:52,869 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #0

2022-04-23 11:42:53,923 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #1

2022-04-23 11:42:54,947 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #2

2022-04-23 11:42:55,972 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #3

2022-04-23 11:42:57,032 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #4

2022-04-23 11:42:58,057 Thread-259 pyisy WARNING connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: retry #5

2022-04-23 11:42:58,058 Thread-259 pyisy ERROR connection:request: Bad ISY Request: http://192.168.4.6:8080/rest/nodes/10972/cmd/DOF 404: Failed after 5 retries

2022-04-23 11:42:58,059 Thread-259 pyisy WARNING nodebase:send_cmd: ISY could not send off command to 10972.

2022-04-23 11:43:32,809 Thread-487 udi_interface WARNING Controller:longPoll: Listen Count = 4

Thoughts on what to try at this point?

Edited April 23, 2022 by pjjameso

[pjjameso]

Switched the HUE port to 80 to see if that makes any difference, Harmony finds the HUE but Im stuck at the point where Harmony asks me to pair with HUE by pressing the center button. Eventually fails the pairing process.

[carealtor]

Make sure you have Listen set to True in the ISY Admin Console.

[Jimbo.Automates]

Port must be something else besides 8080, and 80 is reserved so use something like 8081.

Sent from my Pixel 6 Pro using Tapatalk

[pjjameso]

Changed Hue port to 8081 and checked that listen was true.  Same issue when trying to setup, harmony asks me to "Press the center button in the bridge to pair it with Harmony Hub".

HueEmulator_4-23-2022_31719_PM.zip

[pjjameso]

Tried deleting NS and adding back with the same results.... Just gotta find that special button!

HueEmulator_4-23-2022_35727_PM.zip

[pjjameso]

Well for some reason it decided to pair.... Looks like Im good to go at this point.  Thanks to everyone for the help.