walkman9999 Posted December 4, 2022 Author Share Posted December 4, 2022 I'm attempting to validate this, I think I'm following the suggestion correctly. Please see attached screenshots. When I click on the scene controller I can see that the device ("Kitchen Island") is a controller for the scene ("Low Hang") and that Kitchen Island is part of Low Hang. Is this the validation we're looking for? I'm tempted to delete the device and re-add (discover) to ISY. I understand this will require me to add the device to any scene, but there are not too many scenes to add to. Is this valid? Or, I have a spare switchlink dimmer. Would it be a good idea to swap the one that is in there? Link to comment
Solution lilyoyo1 Posted December 4, 2022 Solution Share Posted December 4, 2022 (edited) 2 hours ago, walkman9999 said: I'm attempting to validate this, I think I'm following the suggestion correctly. Please see attached screenshots. When I click on the scene controller I can see that the device ("Kitchen Island") is a controller for the scene ("Low Hang") and that Kitchen Island is part of Low Hang. Is this the validation we're looking for? I'm tempted to delete the device and re-add (discover) to ISY. I understand this will require me to add the device to any scene, but there are not too many scenes to add to. Is this valid? Or, I have a spare switchlink dimmer. Would it be a good idea to swap the one that is in there? Click on your controller (red) verify all devices that shows up are configured to operate the way you want them to. You can also delete the controller from the scene and re-add it. Doing so will automatically configure the device with the scene attributes. Edited December 4, 2022 by lilyoyo1 2 Link to comment
walkman9999 Posted December 4, 2022 Author Share Posted December 4, 2022 This is the answer. Clicking on the controller and choosing "Copy scene attributes from Low Hang" for each controller set things right. I think a few people had this idea and were presenting it to me in different ways, so would like to give everyone credit. Case closed. Thanks all! Link to comment
Geddy Posted December 4, 2022 Share Posted December 4, 2022 @walkman9999 just know that “Copy Scene” had to be removed in 5.x. So that’s good that you’re on 4.9 to still have that and resolve your issue. I think most are now on 5.x and adjust scenes differently because of that change. 1 Link to comment
Recommended Posts