to_lighter Posted December 3, 2022 Share Posted December 3, 2022 Hi everyone! I bought my first Z Wave device. It is an Enbrighten in wall receptacle. I wired it up, and used the Z-Wave menu to add the device. Worked nicely! However, now in my device list, I see the following (see pic below). Seems like a lot for a simple on off wall outlet. What are all the other entries for? Thanks in advance! Cheers Link to comment Share on other sites More sharing options...
Techman Posted December 4, 2022 Share Posted December 4, 2022 (edited) Some devices will install several nodes, many of which are not necessary or phantom nodes. This is a common issue with Zwave and the ISY. Other controllers may or may not use those nodes. What most of us do is create a folder "unused zwave nodes" and move the nodes you don't need into that folder. Edited December 4, 2022 by Techman 1 Link to comment Share on other sites More sharing options...
to_lighter Posted December 4, 2022 Author Share Posted December 4, 2022 Whew! Thanks for the quick reply. Very helpful! Will do as you suggested to clean things up a bit. Cheers! Link to comment Share on other sites More sharing options...
DennisC Posted December 4, 2022 Share Posted December 4, 2022 One other suggestion is that it is recommended to do an exclude before an include with zwave devices, even new devices. Link to comment Share on other sites More sharing options...
Recommended Posts