Jump to content

Z Wave issues, getting worse!


ILey

Recommended Posts

Hope somebody can help me.

So earlier I articulated my issues with an aeotec temp and humidity sensor. I then tried to add a Z Wave smoke/CO detector, which seemed to add OK but then threw errors, so I deleted it.

I reset the Z wave dongle/board (its a board not a dongle even though the software says dongle?), was that a mistake?

Now when I try to add either device I get no messages at all it just hangs saying trying to add device.

I think my board is version 500, how can I be sure?

My ISY software is 5.3.0

The Z wave info says 6.82.1 for version.

 

Any advice ?

Thanks.

Link to comment
Share on other sites

9 minutes ago, ILey said:

Hope somebody can help me.

So earlier I articulated my issues with an aeotec temp and humidity sensor. I then tried to add a Z Wave smoke/CO detector, which seemed to add OK but then threw errors, so I deleted it.

I reset the Z wave dongle/board (its a board not a dongle even though the software says dongle?), was that a mistake?

Now when I try to add either device I get no messages at all it just hangs saying trying to add device.

I think my board is version 500, how can I be sure?

My ISY software is 5.3.0

The Z wave info says 6.82.1 for version.

 

Any advice ?

Thanks.

https://forum.universal-devices.com/topic/29371-zwave-tips-and-tricks/

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...