jhoulihan Posted January 8, 2023 Posted January 8, 2023 I have the Eisy and Zwave/Zmatter dongle plugged in. Latest version of software for everything. When I try to add a Zwave device, Eisy does not recognize anything. It listens but never finds anything. I have a simple plug switch and also a multisensor motion/temp sensor that I'm trying to pair. Do I need some kind of a ZWave hub or something? Things were working fine with my ISY994i
GJ Software Products Posted January 8, 2023 Posted January 8, 2023 @jhoulihanThere's a known problem with this, UDI is working on a patch. My eisy don't even see the USB: Z-Wave+ Matter module. I'm just planning on holding tight until the patch/build is avaiable.
bigDvette Posted January 8, 2023 Posted January 8, 2023 Mine works fine. My only issue was 2 aerotec repeaters. It would pair them but not create any nodes.
GJ Software Products Posted January 8, 2023 Posted January 8, 2023 @bigDvetteIs that using the USB: Z-Wave+ Matter module and not a Zooz 700? I've tried everything and can't get it to work. I have a ticket open with UDI and they told me a build is on the way.
jhoulihan Posted January 8, 2023 Author Posted January 8, 2023 31 minutes ago, GJ Software Products said: @bigDvetteIs that using the USB: Z-Wave+ Matter module and not a Zooz 700? I've tried everything and can't get it to work. I have a ticket open with UDI and they told me a build is on the way. I'm using the ZWave/ZMatter dongle. Not the Zooz 700
GJ Software Products Posted January 8, 2023 Posted January 8, 2023 @bigDvetteWow! I installed it, checked the Z-Wave checkbox, reboot & when you select Z-Wave on the menu bar it says no dongle found. And if I press Migrate to Z-Wave it winds up in an infinite System Busy loop.
tazman Posted January 8, 2023 Posted January 8, 2023 5 hours ago, jhoulihan said: I have the Eisy and Zwave/Zmatter dongle plugged in. Latest version of software for everything. When I try to add a Zwave device, Eisy does not recognize anything. It listens but never finds anything. I have a simple plug switch and also a multisensor motion/temp sensor that I'm trying to pair. Do I need some kind of a ZWave hub or something? Things were working fine with my ISY994i Did you try to remove before you add?
Techman Posted January 9, 2023 Posted January 9, 2023 Try removing power from the eisy, wait a minute, then let it boot up, which can take a few minutes.
Recommended Posts