JTsao Posted January 17, 2023 Posted January 17, 2023 Trying to get from Polisy/Zooz/2448A7 to eISY/Zooz/2448A7. After restoring the Polisy IoX backup to the eISY, when I go to the programs tab it takes a very long time and then comes up with no programs indicated in the left Program pane area and none in the summary tab. The strange thing is that I get a push message indicating that the ISY was reset - which requires one of the programs to run. Variables, notifications and everything else are all there but no programs. I guess I should point out that I am trying this without plugging in my Zooz or 2448A7 dongles, and I unchecked the boxes for Insteon and Z-Wave on the eISY config. page - I'm keeping the dongles in the Polisy until I feel that the eISY is ready to go - I want to have a working system if the eISY is not ready. The PG3 restore looks OK -the dashboard looks good but I haven't done a deep dive into that yet. Does anyone have any suggestions of what to do at this point?
JTsao Posted January 17, 2023 Author Posted January 17, 2023 NEVER MIND - eISY is now a brick - I tried a factory reset (10 presses) then 5 presses to reboot - had to revert to wired ethernet - it gets an IP address, but refuses ssh connections and does not show up in IoX finder I've tried a couple of factory resets and reboots - what now?
MrBill Posted January 17, 2023 Posted January 17, 2023 28 minutes ago, JTsao said: what now? open a ticket? 1
Javi Posted January 17, 2023 Posted January 17, 2023 1 hour ago, JTsao said: NEVER MIND - eISY is now a brick - I tried a factory reset (10 presses) then 5 presses to reboot - had to revert to wired ethernet - it gets an IP address, but refuses ssh connections and does not show up in IoX finder I've tried a couple of factory resets and reboots - what now? Try resetting networking by pressing the front button 4 times. We are looking into a few similar reports.
JTsao Posted January 17, 2023 Author Posted January 17, 2023 6 hours ago, Javi said: Try resetting networking by pressing the front button 4 times. We are looking into a few similar reports. Thanks but that didn't work either - is there a recovery process where I plug my HDMI monitor and USB keyboard/mouse directly into the eISY? Otherwise, I may have to send it back to UDI to get fixed...
Recommended Posts