TheA2Z Posted August 24, 2023 Posted August 24, 2023 (edited) First week using a zigbee device on my eisy with IoX 5.6.4. It installed and functioned fine, but after a few hours it shows as a disconnected node and quits triggering programs. I had another one, so I installed it. It did the same thing. its about 25 feet away from eisy. Im a bit of a noob with these zigbee devices. Anyone have any tips or tricks? Or could it be IoX related? Edited August 24, 2023 by TheA2Z
Solution DennisC Posted August 24, 2023 Solution Posted August 24, 2023 I wonder if this could be related to the IoX slowdown bug that was recently discovered in 5.6.4. There was a patch, not a version upgrade released yesterday. Did you try installing that by running package update from admin console?
TheA2Z Posted August 24, 2023 Author Posted August 24, 2023 6 minutes ago, DennisC said: I wonder if this could be related to the IoX slowdown bug that was recently discovered in 5.6.4. There was a patch, not a version upgrade released yesterday. Did you try installing that by running package update from admin console? @DennisC Actually have not had a chance yet. Will do so tonight. Hopefully that does the trick. I'll post back results.
TheA2Z Posted August 26, 2023 Author Posted August 26, 2023 Update: it appears to updating to latest patch has fixed the third reality motion dropping off. Its been running for a couple of days and so far, so good. Will chime back in if it acts up again but so far so good. 1
Recommended Posts