Eisy is running well, all devices and programs working as they should. Most of my devices are insteon, with eisy new to me I purchased several ZigBee and ZWave plus devices to test, controlling the devices is fine but after a power outage insteon devices go back to before the power outage the others remain off. Is there a way to have eisy cycle the devices and programs and set them to where they were before the power outage.

 

11 hours ago, MLozevski said:

Eisy is running well, all devices and programs working as they should. Most of my devices are insteon, with eisy new to me I purchased several ZigBee and ZWave plus devices to test, controlling the devices is fine but after a power outage insteon devices go back to before the power outage the others remain off. Is there a way to have eisy cycle the devices and programs and set them to where they were before the power outage.

 

You could create a variable for each device to record the state and then set the variable init vale to maintain it over a power outage.

Then write a start up program to restore those states.