MLozevski Posted October 7, 2023 Posted October 7, 2023 Eisy is running well, all devices and programs working as they should. Most of my devices are insteon, with eisy new to me I purchased several ZigBee and ZWave plus devices to test, controlling the devices is fine but after a power outage insteon devices go back to before the power outage the others remain off. Is there a way to have eisy cycle the devices and programs and set them to where they were before the power outage.
DennisC Posted October 8, 2023 Posted October 8, 2023 11 hours ago, MLozevski said: Eisy is running well, all devices and programs working as they should. Most of my devices are insteon, with eisy new to me I purchased several ZigBee and ZWave plus devices to test, controlling the devices is fine but after a power outage insteon devices go back to before the power outage the others remain off. Is there a way to have eisy cycle the devices and programs and set them to where they were before the power outage. You could create a variable for each device to record the state and then set the variable init vale to maintain it over a power outage. Then write a start up program to restore those states.
Recommended Posts