Envirogreen Posted October 14, 2023 Share Posted October 14, 2023 I’m trying to add my cameras to ud mobile but clearly doing something wrong rtsp://username:password@ipaddress:port/Streaming/Channels/101 Ipaddress - I’m using the internal NIC IPv4 address, couldn’t see anything else port - using 554 which shows as the rtsp port once I get the first working I’m planning on using 102, 103 etc for the different cameras any suggestions would be helpful Link to comment
DennisC Posted October 15, 2023 Share Posted October 15, 2023 22 hours ago, Envirogreen said: Streaming/Channels/101 Is this part a requirement of your camera to connect via rtsp? For my Foscam cameras, after port, I have: /videoMain You need to check the rtsp format required for your camera. Try using the command in something like VLC Media Player to see if you have the correct format. Link to comment
Envirogreen Posted October 15, 2023 Author Share Posted October 15, 2023 Yes it is part of the requirement for the Hikvision cameras. good idea re vlc Link to comment
saninberg Posted October 15, 2023 Share Posted October 15, 2023 Have you checked out this video on youtube. Some settings on camera side need to be changed. Link to comment
Solution bgrubb1 Posted October 15, 2023 Solution Share Posted October 15, 2023 (edited) if as you say, its a NVR and connected to a DVR you will need to adress the DVR In my case I had to enable on the DVR then... rtsp://username:password@DVR.IP.Address:554/chID=1&streamType=main&lnk-Type=tcp Also notice Linux is case sensitive Edited October 15, 2023 by bgrubb1 Link to comment
Envirogreen Posted October 27, 2023 Author Share Posted October 27, 2023 Using the nvr ip + case sensitive + testing with VLC did the trick. Thank you 1 Link to comment
Recommended Posts