joeria Posted September 3 Posted September 3 Hi @Goose66, Thanks so much for writing this! I have installed (and dented and reinstalled) the trial today. The authentication went very smoothly. I have four thermostats in the house. 2 heat only, 1 cool only and one Heat & Cool. On discovery it shows 5 nodes, the house and the four thermostats. For 3 of the thermostats all the data elements are listed below the node entry and load fine into the iox. For the heat & cool thermostat it shows in the PG3x screen with the first line looking just ;ike the others with its unique name, a unique address and in the hint column, the same hint as the three other thermostats but with a trailing ".0". There are no other lines and this thermostat does not load in the iox admin console. Again, I deleted the node and reinstalled it into a new slot but the condition is the same. I'd appreciate any advice or insight. Thanks again! Joe
Solution Goose66 Posted September 3 Solution Posted September 3 Can you send a screen shot of the Nodes screen from the PG3x Dashboard? Also, change the Log Level to “Debug” for the plugin, restart the plugin, then DM me a log package.
Recommended Posts