Getting arrows on my Elk Controller

[srjacob]

What is going on?  None of my outputs are being queried.  See uploaded image.

[paulbates]

Arrows mean the isy identifies it as a dry contact device. This arrow means it's a contact device that controls something... turning it on from iox will trigger the contact. You'll see that on/off status by clicking one of them and looking at the iox panel for it.

Edited yesterday at 04:55 PM by paulbates
I defined the arrows backwards initially

[paulbates]

What would be more helpful would be a view of the ISY's log when it does/doesn't happen, or the event viewer.

However, since it's a dry contact output it should never change from what you set it to. Inputs will do that

Edited yesterday at 05:01 PM by paulbates

[srjacob]

23 minutes ago, paulbates said:

What would be more helpful would be a view of the ISY's log when it does/doesn't happen, or the event viewer.

However, since it's a dry contact output it should never change from what you set it to. Inputs will do that

Actually, some of the outputs are flags and are defined in the Elk, some of the outputs are non-existent because I have to go up to output 197 (which is the relay control for the M1KAM module).

I have never seen the arrows before.  It sure looks like the eisy is trying to go out and get the outputs, but it can't.

 

The logs are attached.

UDReport.xlsx ELK_8-24-2025_12542_PM.zip

[paulbates]

The ISY report looks clean to me. The only thing that looked out of place in the elk log is the most recent 17 entries (I tried to paste them in here and the forum threw a block at me)

Which looks like it happened as the last thing before you pulled the log.

The plugin author will need to take a look.

[srjacob]

1 hour ago, paulbates said:

The ISY report looks clean to me. The only thing that looked out of place in the elk log is the most recent 17 entries (I tried to paste them in here and the forum threw a block at me)

Which looks like it happened as the last thing before you pulled the log.

The plugin author will need to take a look.

Yes, that's what I thought, too.  I just don't know how to contact the plugin author.  If I did, I probably wouldn't have posted this on the forum.  I though if I posted it, the plugin author might read it and respond.

What entries are you referring too?

1 hour ago, paulbates said:

The ISY report looks clean to me. The only thing that looked out of place in the elk log is the most recent 17 entries (I tried to paste them in here and the forum threw a block at me)

Which looks like it happened as the last thing before you pulled the log.

The plugin author will need to take a look.

 

[paulbates]

It's really wierd, the forum blocks me if I paste all or part of the log entries from the elk plugin... Look at the top 20 or so lines, warnings about pyisy

Since you posted this under the plugin, the author will see it, but sometimes they're traveling and it takes a few days.