19 hours ago19 hr I recently added a micro module open/close module to open and close a shade with an up and down wires on the shade motor. I wired the up and down wires to the two terminals on the module for this and used both sense wires for connecting to a dual momentary contact switch. I added the module to ISY and was expecting to see two sub nodes, but only see one. How does one control the up and down functions via the Admin Console?
9 hours ago9 hr It's designed to support a conference room like wall switch support for something like a retractable projection screen where manually throwing the switch runs the screen/shade all the way in either direction. The single iox node is treated the same.There's a calibration procedure in the manual where you to teach the micro-module how long to engage for up and down. After that "On" operates the contacts long enough for up, and "Off" does the some for down.There are other modes defined as well Edited 9 hours ago9 hr by paulbates
Create an account or sign in to comment