💡 The WLED node server for PG3x/eISY is up to 1.5.8 - full control of your WLED controllers from ISY programs and scenes.

Source: github.com/superflytnt/udi-wled-poly
Latest release: v1.5.8

What you get

• Individual power, brightness and RGB color control, effects and palettes, preset loading, effect speed and intensity, transition timing, live override, playlist start/stop, nightlight status and sync-send

• Controller-wide On/Off, Brighten/Dim, brightness and effect commands - the Controller node is a scene responder, so one scene can run all your WLED devices

• Next/Previous Preset commands for cycling presets, including from scenes

• Local-network discovery, manual device configuration, effect-name rebuild at startup, and live status (online count, LED count, average brightness)

Recent fixes

• 1.5.6: Set Color on device nodes now reads the R/G/B parameters where PG3 actually supplies them - no more falling back to white

• 1.5.7/1.5.8: optional heartbeat monitoring. Set the heartbeat_url custom parameter to any heartbeat/cron-monitor URL and the plugin pings it on each short poll (at most once per 60 seconds), even when controllers are off. Leave it empty to disable.

Notes: preset labels are generic IDs (save presets, set nightlight timers and configure sync-receive in WLED itself), and discovery uses IP scanning rather than mDNS. The README covers configuration and the full version history.

Give it a try and post your results here - your WLED firmware version and what worked or didn't helps everyone.

Edited November 8Nov 8 by kaplansa

This sounds like exactly what I have be looking for to control the permanently installed holiday lights on my house through my EISY!

However, I have never installed a node that isn't listed in the plugin store. I am going to have to read up on how to do that.

K