Hi,

I'm guessing my problem is that I have selected z-matter during my conversion to eisy from my old isy. I have a zooz dongle but now I can't change to zooz.

Thus, I am not able to add any of my z-wave devices.

Any help would be greatly appreciated.

Thanks

issue the following url with a browser, which should roll back the switch to ZMatter:

http://<your_IP_address>:8080/rest/zmatter/zwave/deactivateZMatterZWave

Thank you...to clarify I have the zooz 800

The url worked but I still don't see what I saw when I first started the app which was zooz. Now it just shows add z-wave but I'm not finding any devices.

Not sure what I am doing wrong

Did you reboot your controller?

Yes I rebooted it.

It's been awhile, but if I remember correctly, you can revert backto ISY and start over. Check the wiki on migration.

I'm lost....how do I know if it's chosen the correct z-wave device?

the blue light on the zooz flashes when I start to try to add z-wave devices but it doesn't find any. I'm sure this is just a newb issue as I haven't touched the z-wave stuff with isy in a few years.

2 minutes ago, lip said:

I'm lost....how do I know if it's chosen the correct z-wave device?

The Usual way is to go in admin console (not eisy-ui) ,click on Configuration, and see if there is a button offering you to migrate to the ZMatter dongle. If there is, then you're set up for zooz dongle. If not, the do the browser command I posted earlier, reboot, and check again.

ZMatter migration is one way, so an eisy factory reset would be required to revert.

This is intentional, while it currently says Z-Matter this is basically migration from Z-Wave 500 to 700. There is no way to go back to 500 from 700.