kyleohme Posted September 9, 2010 Share Posted September 9, 2010 Folks, I just dug up my older unit and installed the latest firmware 2.7.15 i cleared everyting out and now i am unable to even save the simplest of the simple program ... 'send x10 'I9/On (3)' when i go to save i get 2 dialog boxes with "Request Failed" common? I cant save anything in programing Link to comment
Sub-Routine Posted September 10, 2010 Share Posted September 10, 2010 Is the Error LED on or blinking on the ISY? That would be an issue with the SD card. Otherwise this usually indicates a firewall blocking writes to the ISY. Rand Link to comment
kyleohme Posted October 19, 2010 Author Share Posted October 19, 2010 no firwall on the pc i am using - and no error (I did reseat the SD card) cant really do anything with it if i cant save a program =( Link to comment
Michel Kohanim Posted October 19, 2010 Share Posted October 19, 2010 Hello kyleohme, Please go to Tools | Diagnostics | PLM Status/Info and make sure the status is Connected. If not, then you have PLM issues ==> ISY is in Safe Mode and that's the reason you cannot save any programs. With kind regards, Michel Link to comment
kyleohme Posted October 19, 2010 Author Share Posted October 19, 2010 that would be the issue - i could never get this to work right - so now what? Link to comment
Michel Kohanim Posted October 19, 2010 Share Posted October 19, 2010 Hello kyleohme, You need a new/repalcement PLM! With kind regards, Michel Link to comment
Brian H Posted October 19, 2010 Share Posted October 19, 2010 You may also want to look at the connector on the PLM and make sure the pins are not bent up too high. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.