I apologize if this dumb newby question has already been answered but I have searched and come up empty handed.

 

I have an ISY-99i Pro running v.2.7.15. I recently purchased a RemoteLinc and three dual-band LampLincs to add to my non-RF network. Currently my PLM is the older 2412S non-RF model, but I also have a 2413S dual band PLM installed simply as a phase bridge (it is not connected to the ISY). I would like to be able to use the RemoteLinc to control other scenes in the network, so I go to the Admin Console and select "Link a RemoteLinc." I put the RemoteLinc in communications mode and press OK. I then get a message to input the Name and Address (the device type is already filled in with RemoteLinc). Now here's the problem: I don't know how to tell what the RemoteLinc Address is and without that, it won't work! There is no address (i.e., xx.yy.zz) listed on the device, so what can I do? Thanks in advance for any assistance!

Hello bushmg,

 

Apologies for the inconvenience. Normally, the address is on a label in the battery compartment and sometimes right underneath the batteries.

 

With kind regards,

Michel

The address is located on a label affixed to the lower vertical edge of the battery compartment. The lower/bottom battery has to be removed to see it.

Ouch! Boy, is my face red! Thanks to all for the rapid and helpful replies

Well I was also use to the label being on the rear of the module or face plate of switches.

 

Took me awhile to find it in my RemoLincs also.

They could not have a found a better location if they trying to hid it on purpose.