cwilli Posted December 13, 2010 Posted December 13, 2010 Our power flickered a few times on Saturday - it went off for a second and then came back on. After this happened, I noticed my lights weren't coming on at the correct time. I went to check out ISY. I was able to login but when I went the program summary tab I received this message: [-10002] SSL decoding PMOD failed [n/a] All of my programs were missing - botht program summary and details tabs were blank. I tried restoring from a backup, reflashing the firmware to 2.7.15, etc. Each time I check, I get the same error. Any ideas? Thanks! Chris
Michel Kohanim Posted December 13, 2010 Posted December 13, 2010 Hi Chris, Please go to Tools | Diagnostics | PLM Status/Info. If it shows disconnected, then your PLM is gone bad and therefore ISY is in Safe Mode (you do not see your programs). With kind regards, Michel
cwilli Posted December 13, 2010 Author Posted December 13, 2010 I was looking through the tools->diagnostics menu and noticed that it said my PLM was not connected. I went upstairs to look at the ISY and the PLM light wasn't on. I unplugged the PLM and plugged it back in, came downstairs, restarted the ISY software, and everything showed up again - including all my programs! The power flicker must have frozen up the PLM.
cwilli Posted December 13, 2010 Author Posted December 13, 2010 I have to say - you guys are fast! I tried to post the solution faster than you, but you beat me to it. Thank you very much. Chris
Sub-Routine Posted December 13, 2010 Posted December 13, 2010 HI Chris, sometimes this a PLM affliction. Would you please try unplugging the PLM for 30 seconds and then plugging it back in (without holding any buttons). Let the ISY/PLM reboot and let us know if you still have issues. Rand Our power flickered a few times on Saturday - it went off for a second and then came back on. After this happened, I noticed my lights weren't coming on at the correct time. I went to check out ISY. I was able to login but when I went the program summary tab I received this message: [-10002] SSL decoding PMOD failed [n/a] All of my programs were missing - botht program summary and details tabs were blank. I tried restoring from a backup, reflashing the firmware to 2.7.15, etc. Each time I check, I get the same error. Any ideas? Thanks! Chris
Recommended Posts