I would like to know if this is on the UDI road map. In the House Linc 2 the software application has the ability to upload new updates to any RF Motion sensor. Once the user awakens the RF Motion sensor it will remain in a ON state to receive any new updated programming.

 

I know this question has been asked quite a few times and I have received various replies in some cases. But, unless I am missing the obvious how is this accomplished *Assuming* this feature exists? To be clear I am asking that (I) simply have to walk in the path of the RF Motion sensor to awaken it, and then the unit will remain in this state until all new programming / firmware updates are loaded.

 

Currently, I have to climb up on a blasted ladder and remove said sensor, remove screw, cover, and then hold the idiot button until the LED starts flashing. Having more than 12 of these sensor(s) deployed and some being as high as 20 feet on the outside is NOT a fun task!

 

I would greatly appreciate if THIS feature could be pushed forward in the next few releases. As this is one of the major holes lacking in the power of the ISY platform.

 

Much Thanks

 

Teken . . .

Hi Teken,

 

No, we cannot support this feature as it causes major synchronization problems and additional support issues.

 

With kind regards,

Michel