tibbar

Hi. I just received my first Mimo2+. Included it to ISY. It shows as: _1 Multilevel Sensor and _147 Binary Switch I'm trying it with my NICE APPOLO 1050 gate opener. 1. Connected Sig1 to gate output- programed for gate MOVING. 2. Connected Relay1 to gate input - programed for STEP operation. I can control the gate operation with ISY so the switch part works but ISY does not sense the gate moving. With the gate moving I can see SIG1 led on Mmo2+ control board change status (so it is receiving signal from gate) but ISY is not aware of it. Gate motherboard has NC, COM, NO connections for output. I tryed combination of NC+COM and NO+COM with same effect. Is there anything else I should do? P.S. I'm on 5.0.10- looks like multichannel is not working right with Mimo2+. Thanks.

What about any of v5. alphas? I could use 2 relays . Zwave plus is also nice.

Hi. I would like to add Zwave in-out module to my install. Found MimoLite and Mimo2+. Mimo2+ looks like a better device with 2in and 2 out signals and Zwave Plus. Is Mimo2+ supported by ISY? Thanks

Thanks. I got it working now. Special thanks go to Jackal and Barry Gordon.

Hi. Not sure if I'm blind today or just have a brain **** but for life of me I can't find any instructions on setting up Echo with ISY without portal using RaspberryPi. Could someone please point me in right direction. Thanks.

Thanks guys. ISY time is correct. I'll give the two program approach (looks good) tomorrow during day time hours.

Kitchen Door Open - [iD 0005][Parent 0001] If From Sunset + 15 minutes To Sunrise - 15 minutes (next day) And Control 'ZW Kitchen Door Lock' is switched Key/Manually Unlocked Then Set Scene 'Sofit / Sofit Backlanding' On Set Scene 'Sofit / Sofit Deck' Fast On Set Scene 'Sofit / Sofit Driveway' Fast On Set Scene 'Outside Rec Driveway' On Set Scene 'Garage Front Outside' On Else - No Actions - (To add one, press 'Action') This has run fine for quite a while but after last couple updates (current v.4.3.26) but lately light come on when the door is open in the middle of the day- why? What I would like is to lights to turn on when the door lock is unlocked but only when is "dark"- - 15 min after sunset to 15 min before sunrise. Any ideas?

I've figured out the problem. I'm using Vera3 for my zwave door locks and thermostat and I had a Denon plugin running Which is using telnet ( I guess) and could not connect to denon with Isy. As soon as I shot down Vera everything was good.

Hello. I'm tring this with AVR-3312ci but no luck. Anybody willing to help. It is the only reason I just purchased network module. Thanks.