io_guy Posted October 7, 2013 Share Posted October 7, 2013 So my next Insteon issue... I recently (a month ago) switched our my PLM (it was dead) and things seemed to go ok. I have 2 devices that aren't communicating now (not sure if it's related to above, that's why I mentioned it). A SwitchLinc and KPL Dimmer (on the same circuit) have always caused me a little grief - had to do the odd restore to the KPL. Tonight when logging into the console I notice I couldn't communicate with either. Thought maybe noise so I turned everything else off on that circuit, no go. Tried to query and restore, no go. When I tried to restore the SL, ISY's event log just mentioned restoring but did nothing. I deleted the device, tried to re-add it and no go. On to the KPL, I pulled the air gap and left it off for a while. Now when I try to power it back up all the KPL lights go on very dim and the unit cycles the main load and beeps every 2 seconds or so. I have to pull the air gap to keep it from going nuts. Do I just call both these devices dead? I don't see anything relevant in the logs. Anything I should try? I tired to factory reset both devices but neither seem to behave properly - holding in the set button never gives me the long beep behavior. Link to comment Share on other sites More sharing options...
Michel Kohanim Posted October 7, 2013 Share Posted October 7, 2013 Hi io_guy, As hard as it is, have you tried moving them to different locations? If you still have the same issue at a different location then I would suspect that they are both dead. With kind regards, Michel Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.