FarmerGeek Posted December 22, 2015 Posted December 22, 2015 Added three inputs on my ELK. How do i get ISY to see the new inputs? I do have the ELK module.
apostolakisl Posted December 22, 2015 Posted December 22, 2015 configuation/elk/configuration refresh topolgy
FarmerGeek Posted December 22, 2015 Author Posted December 22, 2015 Did that. Just tried again and this time I notest that the button started fluxuating. Does that mean that ISY is getting the new typology and when it finished the button stops fluxuating? If it does I may have not waited long enough.
Michel Kohanim Posted December 22, 2015 Posted December 22, 2015 Hi FarmerGeek, Are you using port 2601 or 2101? Please note that you cannot use 2601 yet. With kind regards,Michel
FarmerGeek Posted December 23, 2015 Author Posted December 23, 2015 I am using 2101. I pressed the refresh topology button and let it run for 20 min or so. I could see the three new inputs but the status was blank. This AM the status was filled in. Not sure why the delay but all looks good now.
Michel Kohanim Posted December 23, 2015 Posted December 23, 2015 Hi FarmerGeek, Please note that if you are also connected in ELK RP, then ISY cannot communicate with ELK. With kind regards, Michel
Recommended Posts
Archived
This topic is now archived and is closed to further replies.