TheWabit Posted December 28, 2015 Share Posted December 28, 2015 Got my Fanlinc all setup. When selecting high on the fan motor through the admin console, it turns like it is on low. I believe I selected high before I started the transition (it is possible I pulled the chain the wrong number of times). And if I didn't set it right to begin with, how do I fix it? Thanks Link to comment
apostolakisl Posted December 28, 2015 Share Posted December 28, 2015 Turn the fanlinc on high, then pull the string on the fan until it goes to full speed. Link to comment
TheWabit Posted December 28, 2015 Author Share Posted December 28, 2015 Sorry - I should have said that - I tried that first and it didn't change. Link to comment
TheWabit Posted December 28, 2015 Author Share Posted December 28, 2015 Disregard - I figured it out. Too embarrassed to tell what I did wrong. Link to comment
fryfrog Posted December 30, 2015 Share Posted December 30, 2015 Disregard - I figured it out. Too embarrassed to tell what I did wrong. Please tell, it could help someone in the future... and give us all a good chuckle! Link to comment
TheWabit Posted December 30, 2015 Author Share Posted December 30, 2015 Ha! I was pulling the wrong (light) chain instead of the fan chain! Dangit Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.