danncas Posted December 22, 2019 Posted December 22, 2019 I just installed a fanlinc with a 6 button keypad. Every thing works fine. 4 scenes. I ungrouped 4 of the button. My question is WHY SHOULD I HAVE NOT DONE THIS??????????????? I read someplace this is not a good idea Every thing works fine with out adding all the button to the scenes and adjusting it.
lilyoyo1 Posted January 4, 2020 Posted January 4, 2020 On 12/21/2019 at 10:45 PM, danncas said: I just installed a fanlinc with a 6 button keypad. Every thing works fine. 4 scenes. I ungrouped 4 of the button. My question is WHY SHOULD I HAVE NOT DONE THIS??????????????? I read someplace this is not a good idea Every thing works fine with out adding all the button to the scenes and adjusting it. The warning that pops up when you try to use button groupings explains why it's a bad idea. For your setup at this point (and possibly forever) you won't have issues. However should something be reset, programs based off status of button etc be used the short comings will show up and cause problems
Recommended Posts
Archived
This topic is now archived and is closed to further replies.