Jump to content

Recommended Posts

Posted

What are each of the 3 LEDs used for?

The right most LED is continually flashing. I think it started after I initiated a Polisy Update. It's been 20 minutes, still flashing.

  • Like 1
Posted

It continued to flash for a couple hours. I did a Polisy reboot but that didn't help. So I did a Polisy shutdown and then pulled the plug. Everything started up okay and now the light is out. Just the left most LED is on. So I guess everything is normal again.

Posted

Sounds like you just did a major upgrade.

I have seen my RPis take 5 to 6 hours for a major upgrade, including most packages and an OS upgrade.

Sent from my SM-G781W using Tapatalk

Posted
14 minutes ago, larryllix said:

Sounds like you just did a major upgrade.

I have seen my RPis take 5 to 6 hours for a major upgrade, including most packages and an OS upgrade.

Sent from my SM-G781W using Tapatalk
 

I hope I didn’t ruin something by pulling the plug. Seems okay. BTW, I don’t see how to backup Polisy, just a restore. Can it be backed up to a network drive?

Posted
53 minutes ago, vbphil said:

Can it be backed up to a network drive?

Under Settings > Polisy Configuration, click the [Download] button right above and save the file wherever you want.

image.png.6494997999249d7117bfe788050d6f1d.png

 

  • Like 1
Posted
1 minute ago, DaveStLou said:

Under Settings > Polisy Configuration, click the [Download] button right above and save the file wherever you want.

image.png.6494997999249d7117bfe788050d6f1d.png

 

Duh? I saw that and thought Download to Polisy. Does it backup the whole system or just Polygot node server installs? Thanks. Phil

Posted
17 minutes ago, DaveStLou said:

It's just the node servers.

Okay thanks. One last question. Any idea what the LEDs indicate?

Posted (edited)
4 hours ago, vbphil said:

I hope I didn’t ruin something by pulling the plug. Seems okay. BTW, I don’t see how to backup Polisy, just a restore. Can it be backed up to a network drive?

I doubt it but with linux (RPi) and freeBSD (polisy) you can run the update/upgrade lines again and it will sort out what isn't up to date.

Edited by larryllix
Posted
17 hours ago, lilyoyo1 said:

I can't find this in the WiKi.

UDI Support gave me this information.

 

Quote

 

Left = Power

Middle = Tx

Right = Rx

Left + Middle + Right blinking = error

Middle and/or Right blinking = upgrading (this may take a while depending on the number of packages)

 

 

  • Like 1
  • Thanks 1
Posted
8 minutes ago, vbphil said:

I can't find this in the WiKi.

UDI Support gave me this information.

I'm glad you asked them.  I've been wondering since you asked the question.  My Polisy's are located in a place where I never see them unless I specifically go there to add/change or unpower/repower something.  After you asked I looked at the same wiki page expecting the answer to be there, but it really isn't.  Other than power tho, I'm not sure I would be confident reading the meaning... if I needed to know because a specific problem was attracting my eye towards them I'd probably email support anyway.

Guest
This topic is now closed to further replies.

×
×
  • Create New...