skunkiechris Posted February 18, 2023 Share Posted February 18, 2023 (edited) Hi...migrating from a Polisy with the Zooz dongle to the ZMatter board. The plugged in Z-Wave devices (various) and door locks (Kwikset) worked fine. However, not a single motion sensor (Zooz ZSE-09, Dome DMMS-1) or leak detector (Ecolink FLF-ZWAVE5-ECO) would interview after many, many attempts and bringing the devices directly next to Polisy. (Operating on 5.5.6) I tried reducing speed, no help. At this point I've rolled back. Has anyone had any success with any of these devices? Any suggestions? I have 8 of those motion detectors and 3 of the leak detectors. Also I saw this asked in another post but there was no reply, is there no way to see the routing info any longer? Thanks... Edit: Realizing now that I probably should have captured ZWAY.LOG to provide here. 🤦♂️ I'll go back and do that... Edited February 18, 2023 by skunkiechris Link to comment
DennisC Posted February 18, 2023 Share Posted February 18, 2023 12 hours ago, skunkiechris said: Hi...migrating from a Polisy with the Zooz dongle to the ZMatter board. The plugged in Z-Wave devices (various) and door locks (Kwikset) worked fine. However, not a single motion sensor (Zooz ZSE-09, Dome DMMS-1) or leak detector (Ecolink FLF-ZWAVE5-ECO) would interview after many, many attempts and bringing the devices directly next to Polisy. (Operating on 5.5.6) I tried reducing speed, no help. At this point I've rolled back. Has anyone had any success with any of these devices? Any suggestions? I have 8 of those motion detectors and 3 of the leak detectors. Also I saw this asked in another post but there was no reply, is there no way to see the routing info any longer? Thanks... Edit: Realizing now that I probably should have captured ZWAY.LOG to provide here. 🤦♂️ I'll go back and do that... Try updating to the latest version, 5.5.7 and see if that corrects your issue. Link to comment
Hoosier Daddy Posted April 2, 2023 Share Posted April 2, 2023 @skunkiechris, did you come up with a solution? Link to comment
Recommended Posts