Techman Posted January 20 Posted January 20 (edited) What's the device you're trying to remove? Is it battery or a/c powered? Have you tried a controller reboot Edited January 20 by Techman
Techman Posted January 20 Posted January 20 (edited) Did you put the blinds motor into the linking mode before trying to remove it? Edited January 20 by Techman
Techman Posted January 20 Posted January 20 You can also try, under the Zwave menu, remove failed node
RPerrault Posted January 20 Author Posted January 20 placed the isy in exclude - then pressed the button - nothing used the 'remove failed node' and get the above
Techman Posted January 20 Posted January 20 (edited) Have you tried removing/exluding the device rather than just the node Did you try rebooting ISY Edited January 20 by Techman
RPerrault Posted January 20 Author Posted January 20 not sure what the difference is - this is what the devices look like i think this one was added twice - and i might have a battery problem - it should be fully charged but i powered it with the charging device and it might be responding - it might be that i included it with it plugged in and it is not seen as a battery powered device lemme look at x-ray
Techman Posted January 20 Posted January 20 (edited) Is the motor working correctly? If you only have one motor and it's showing up twice, then try a reboot. If the reboot doesn't correct it then delete the duplicate motor entry. Edited January 20 by Techman
RPerrault Posted January 20 Author Posted January 20 using the motor control node the device stopped responding so i was replacing it - worked fine for a week - then nothing - no responding at all - so i was going to replace it - after removing the failed node
Techman Posted January 20 Posted January 20 Rather than removing the node, can you remove the device. Are you trying to replace the existing motor with a new motor
RPerrault Posted January 20 Author Posted January 20 yes - but have never used the replace on a z-wave how do i remove the device rather than the node?
Techman Posted January 20 Posted January 20 First plug the battery charger into the motor, then in the zwave menu click on remove a zwave device and then put the motor into the linking mode. I'm assuming that your controller is a eisy/polisy and you're using the Zmatter dongle
RPerrault Posted January 20 Author Posted January 20 oh - yes - i tried that - no response i am using the eisy with whatever radio it uses for z-wave - i do NOT have 'zmatter'' enabled (whatever that is) i do have z-wave enabled
RPerrault Posted January 20 Author Posted January 20 tried exclude device with it plugged in - it excluded might be the battery - i'll replace it
Techman Posted January 20 Posted January 20 1 minute ago, RPerrault said: tried exclude device with it plugged in - it excluded might be the battery - i'll replace it I had that happen with one of my motors, the self contained battery failed and I had to replace the entire motor. Glad you were able to exclude it. Is the battery removable or do you have to replace the entire motor.
RPerrault Posted January 20 Author Posted January 20 the battery is its own unit - plugs into the motor - i have extra units that i can rob a battery from
Recommended Posts