RCottam Posted June 17 Posted June 17 I installed the WLED Plugin on my EISY and cannot figure out how to connect it to my lights. I looked on Github and was confused with what I saw. Can someone list the steps to connect the EISY to a WLED controller or point me to where they are? This is the Add Node dialog in the Admin Console for the WLED Plugin. No matter what I try, I get an error.
Geddy Posted June 17 Posted June 17 @RCottam doesn’t look like this plugin is being supported any further. According to the posts recently:
bpwwer Posted June 17 Posted June 17 16 hours ago, RCottam said: I installed the WLED Plugin on my EISY and cannot figure out how to connect it to my lights. I looked on Github and was confused with what I saw. Can someone list the steps to connect the EISY to a WLED controller or point me to where they are? This is the Add Node dialog in the Admin Console for the WLED Plugin. No matter what I try, I get an error. Ignore that menu on the admin console. I don't believe it works for any PG3 plug-in. All configuration should be done using the PG3 UI. The configuration instructions for the WLED plug-in aren't very clear. My guess is that you have to create a custom parameter with the key being a name and the value being a comma separated list of ip address for the WLED lights. So something like: key=WLED_LIGHTS value=192.168.1.4,192.168.1.5
K-bert Posted June 20 Posted June 20 Like bpwwer said, its all in the PG3 interface. Mine is set up as such: Key = host Value = 192.168.X.XXX After saving the changes and restarting the Admin Console it was added. -K
Recommended Posts