There are my scenes and the voice commands. They worked great until I noticed this morning when I say "Turn on basement 40% it tells me,

"I found more than one device with basement 40%...."

Again, this is new and I'm not sure how to fix it.

@andrew77 Have you happened to have updated to Alexa+? If so, tell it to revert. Alexa+ is causing issues with home automation systems (there have been other posts here about it).

Try deleting the "basement" (50515) scene from the UD Portal portal. It should remove it from the Alexa app, but might need to delete it in there too. Since it's a "scene" I'm not sure how it shows up on the app these days. Old posts suggested scenes aren't displayed in the Alexa app and since they got rid of the website access it's a little more difficult to clean up devices.

More than likely Amazon has updated Alexa just enough that when you have one device that is "basement" and another that is "basement forty percent" it could be considering if you set the "basement" to 40% that's the same device as the "basement forty percent". Does it work with other percent requests? Or is it ONLY the 40% trigger?

Do you have multiple devices in this scene or is this just controlling a single device to a set % of brightness? If it's just a single device then I wouldn't have scenes for set brightness and just tell Alexa to set it to that percent. I have a few dimmers exposed to Alexa and just say, "Alexa, set x-lamp/light to y%".

23 hours ago, Geddy said:

@andrew77 Have you happened to have updated to Alexa+? If so, tell it to revert. Alexa+ is causing issues with home automation systems (there have been other posts here about it).

Try deleting the "basement" (50515) scene from the UD Portal portal. It should remove it from the Alexa app, but might need to delete it in there too. Since it's a "scene" I'm not sure how it shows up on the app these days. Old posts suggested scenes aren't displayed in the Alexa app and since they got rid of the website access it's a little more difficult to clean up devices.

More than likely Amazon has updated Alexa just enough that when you have one device that is "basement" and another that is "basement forty percent" it could be considering if you set the "basement" to 40% that's the same device as the "basement forty percent". Does it work with other percent requests? Or is it ONLY the 40% trigger?

Do you have multiple devices in this scene or is this just controlling a single device to a set % of brightness? If it's just a single device then I wouldn't have scenes for set brightness and just tell Alexa to set it to that percent. I have a few dimmers exposed to Alexa and just say, "Alexa, set x-lamp/light to y%".

I'm not sure what Alexa+ is. How would I go about finding out if that happened?

If I make an alternate voice command (Downstairs twenty percent) it responds fine. Then I add Downstairs thirty percent and it says There Are A Few Things Named Downstairs,. Give them individual names etc.

This is new since I updated to 6.0.0

They all worked fine before.

I have Bathroom 10% Bathroom 20% etc and they all work fine. Theres something about 'basement' that it doesn't like recently.

I can tell Alexa to turn on Basement 100% and turn off Basement 100% and those scenes both work. I just checked my Portal and theres no Spoken or Alternate spoken for Basement 100%)

I didn't take 'Basement fifteen percent' out of the portal and put it back in and it works now. I tried the same with 20% and no luck.

I went to Alexa's iPhone app and found there were doubles of scenes (two 40% etc) and deleting them has started fixing the issue. I also noticed my main basement scene was missing. I hope this is the final solution.

I'm unclear why Alexa doubled some scenes randomly.

I'll check back in when I think I've got it back to normal again