skerke Posted March 14, 2008 Posted March 14, 2008 hello. just finished putting my last two insteon switches a fe wlamp modules to go an I am x10 free (except for motion detectors) Anyhow- Iread thre threaads and I must be dumb I could not for the life of me figure out how to get an all off button to work. I have all the loads in a scene calle dall off with a button as the contrl (button b on keypadlinc) The good: I hit the buttton - every load except for the load controlle dby the kyapd linc that has button b(my all off) goes off. The bad. The button also turns all the lights on. now I read some good stuff out herebut gifure this is quite basic..any help is greatly appreciated.. DJS
Algorithm Posted March 14, 2008 Posted March 14, 2008 Hello DJS, Welcome to the forum! Your question is a very good one. The thread 'All Off' button/status -- one more twist discusses several ways of doing what you want. I do hope it will be of help to you. Please let us know how you make out.
skerke Posted March 14, 2008 Author Posted March 14, 2008 i'll check it out. thanks. my other thoughts were: set on level to 0% inside scene for all reponders - let isy reset status of button to off for the controller
Algorithm Posted March 14, 2008 Posted March 14, 2008 i'll check it out. thanks. my other thoughts were: set on level to 0% inside scene for all reponders - let isy reset status of button to off for the controller DJS, very good! That is one of the options discussed in the thread, and there are others for your consideration as well. Please do let us know how it goes.
Sub-Routine Posted March 14, 2008 Posted March 14, 2008 You can set the button to non-toggle off if that is good for you. Rand
Recommended Posts