Jump to content
View in the app

A better way to browse. Learn more.
Universal Devices Forum

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Irrigation Module Question

bobmre
in ISY994

Featured Replies

Posted

At the end of my sprinkler program I added Irrigation - Cycle Complete, which did not seem to do anything. The irrigation requirments were still the same. I had to add Irrigation - Reset Variables to clear the irrigation requirements. What does cycles complete do?

 

Bob Moore

  • Author

I am using version 3.3.10.

 

Bob

Mr. Moore,

 

Are you certain that NOTHING changed? Please note that cycle complete uses the following algorithm:

Absorption Factor * Water Applied per Irrigation Cycle. So, if absorption factor is less than 100%, then the number might be too small for you to notice.

 

I just made a simple test and it works fine here.

 

With kind regards,

Michel

  • Author

I tested it again and it did change the irrigation requirement.

 

Bob Moore

Guest
This topic is now closed to further replies.
Go to topic listing

Configure browser push notifications
Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.