drprm1

Pretty sure I stopped the regular node for this test...Did another log. Started test plug-in and let it find all nodes for a few minutes then I used the AC to lock, unlock, and query several times then locked and unlocked several times manually. (regular node was stopped) Here's the log YoLinkTest_1-10-2025_80937_AM.zip

When using the test plug-in none of the nodes seem to update in the AC.

Here is the log. I controlled the lock several times manually and from AC YoLinkTest_1-10-2025_80937_AM.zip

Lock shows up in AC but controls don’t change the lock’s state

Here you go YoLinkTest_1-9-2025_124948_PM.zip

I will at halftime 😜

Okay great! My lock is now showing up in the test node.Didn’t see what it looked like like in the AC I’ll look forward to the production update and thanks!

Installed in different slot, configured and started. Not showing connected

installed 1.3.13 and still not showing connected. Restarted several times and not connected

Still shows 1.3.12 in store? sorry, refreshed and got it.

how long before 1.3.13 shows up in nodeserver store??

Also tried deleting test node and reinstalling in new slot. After configuration it never shows connected. When I try and start it show “already running” but it’s not connected. log is empty

Updated to 1.3.12 with no joy. YoLinkTest_1-9-2025_124948_PM.zip

Stopped yolink node, installed the test node, configured it and ran it. Only three devices showed up here out of 37. Unfortunately no lock. YoLinkTest_1-9-2025_122103_PM.zip

Pardon my ignorance here but are you saying to install the test node in its own slot to see if my lock shows up?( don’t want to mess up what I already have) Thanks

Still not showing up in AC Assume you want log. Will send it in morning

Thought is was probably the poll settings. Thanks

How often are temp sensors readings updated to eisy?

Not working for me so I’ll have to wait Thanks for checking into it.

Yes I have a hub and yes I use the Yolink plugin. I have about 30 other Yolink nodes that show up in the AC…..all except my new lock. Was hoping Panda had a solution here.

Got a new smart lock from Yolink. The fingerprint deadbolt YS7616-UC. I realize it’s new and maybe not supported yet but it is classified as a smart lock which I believe is supported? Anyway I’ve done everything to try to get it to show up in AC with no success. Is it supported yet? thanks!

I see you experimented with deleting switch then adding it back…Did you happen to hard reset it a few times to get rid of any links before adding it back. Go to programs and using find/replace make sure the switch isn’t in any programs.

Did you try hitting the set button on one device? Then restarting nodeserver and AC?

Are there nodes showing on the PG3x dashboard. Have you tried restarting the AC? Dont know how long the interval to report is for the leak sensor but you might try hitting the set button on the sensor then restarting AC to see if it shows up.

I did, but I had them switched….. thanks