drprm1

All three $80

Same here

I too have hub. On 4.4 but still having to restart YoLink NS at least daily. Haven't looked more often to catch when it stops communication.

"Restarting the NS seemed to remove and then add the YoLink devices" This is what I see too....Do all node servers do this? I never noticed

on 3.0.62...will update now

Not sure if this means anything but when I look at this Node server in dashboard it will show, in my case, that I have ten nodes. If I click on the node tab it will often show nothing. (ie the nodes seem to disappear)..They are all present in the configuration but seem to come and go under the node tab Maybe connecting, disconnecting?

Rebooted polyglot and temps are updated for now. I'll keep an eye on it. Thx

Totally agree with palayman. Relying more and more on YoLink than CAO tags (esp now with NS) Using mostly for temperature monitoring...Nothing critical till NS gets dialed in. My favorite is the pool temperature monitor. Had CAO tag monitor for it which would always get moisture inside and die. (tried four different ones which all leaked and died). Got a YoLink monitor which has been rock solid for eight months. I even found it at the bottom of the pool once.

Only running AC and UD Mobile....And YoLink app on phone

Tried many restarts….Hope one of these is what you need YoLink_6-14-2022_54817_PM.zip YoLink_6-14-2022_54847_PM.zip

0.4.2 Not sure if this started with this version but none of my three temperature probes are updating....They do show up in AC just not with the updated temperatures......

A thousand pardons. This is what I should’ve shown

While there is no control over the door on the node page of AC there is in UD mobile

Can’t speak for motion detectors as I have none. The nodes show up in programming Here are programming options for finger and a plug

Installed 4.0 Nothing different on any of my nodes.

The finger update does control the door by hitting the toggle button…. Kind of a pain to have to change over to a different screen to tell if the door is open or closed I had the garage status Yolink before getting the finger controller. (They have to change the name) When finger was set up it meshed with the status device to show on one page.

Greatly appreciate your help with YoLink!

When I implemented finger it seemed to take control of the garage sensor ns. Not sure how

I Well I don’t have it

Absolutely!

Sorry, I have no node called “toggle” Thanks for you help though

Again, where do you see “toggle” Is it a single node or associated with something else?

What is this node called? I have no “toggle” anywhere. I’m also using the “finger” to control the garage door. Don’t know how that affects things. Should toggle be on this page??

Would also like a control setting in garage door to be able to open/close.