I have looked all over and read and read. So now I'm just asking

I have three motion sensors, one the side one on the front, and one on the side of home. The problem I'm having is that when the lights go off and you walk back in the area they dont come back on.

What I want is to have them come on when motion is detected and stay on for six minutes. If montion is still detected stay on, if no motion is detected wait 6 minutes and go out. But if motion is detect before the six minute start the count all over. Also if the switch to the light is turned on manualy dont do any thing other then turn on the lights, and when the switch is off then resume motion sensing.

My motion sensor are set ON all the time and send on OFF

anyone have a good program that work that I can use.

THANKS

Hi danncas,

 

What you need is:

If
       Control 'Main Bath Motion.1-Sensor' is switched On
   And Control 'Main Bath Motion.1-Sensor' is not switched Off

Then
       Set 'Main Bath Lights' On
       Wait  6 minutes 
       Set 'Main Bath Lights' Off

 

With kind regards,

Michel

Michel,

 

This is a duplicate post. The original poster has not been back.