Jump to content

Motion Sensor 2842-222 v.24 Low Bat


JCBond

Recommended Posts

Posted

I have several Motion Sensors 2842-222 v.24 and I have noticed that whenever the Low Bat status turns on. I can't reset it back to off even though I have replaced the battery.

 

The only way I have found so far that works is to delete the sensor and re-add it again to the system.

 

Has anyone else seen this issue? Is there something I am not doing that I should?

Posted

After replacing the battery, set the MS to linking mode and query it. Another solution is to use a program to update the sensor:

 

IN Front Hall Sensor
If
        Control 'IN / Devices / IN Front Hall-Sensor' is switched On
 
Then
        Set 'IN / Devices / IN Front Hall-Sensor' Write Device Updates
 
Else
   - No Actions - (To add one, press 'Action')
 
I actually have the program disabled (to save the battery) and I run [THEN] when needed.

Posted (edited)

MS units are not capable of sending LowBatt Off, only On.

 

UDI has created a workaround by faking the Off in ISY. See Michel's post above.

Edited by larryllix
Guest
This topic is now closed to further replies.

×
×
  • Create New...