jblackst5000 Posted July 20, 2020 Share Posted July 20, 2020 I have two IOLinc's that I use to control my two garage doors. Everything works fine until I re-boot my ISY. I just did this a few days ago and when I push my garage door button the garage door go up about half way and stops. Sometimes it even goes up half way and then closes on it's on. If I unplug my IOLinc the garage door opener works fine. When my ISY re-booted it must have made my IOLinc out of sync. The only way I could fix it is to delete my IOLinc (GarageDoor-Sensor/GarageDoor-Relay) and to re-install. It then creates entries 1. GarageDoor-Sensor 2. GarageDoor-Relay When I do that everything works fine. I am sure there is a better and much easier way of fixing this problem should it occur again. Thanks as usual for all your help. Link to comment
Scud Posted July 22, 2020 Share Posted July 22, 2020 What mode do you have your Relay in? My understanding is if you have Trigger Reverse selected it will be un-selected after a power outage or reboot. Link to comment
larryllix Posted July 22, 2020 Share Posted July 22, 2020 1 hour ago, Scud said: What mode do you have your Relay in? My understanding is if you have Trigger Reverse selected it will be un-selected after a power outage or reboot. Yeah and 3:00 AM queries also show up un-reversed and cause grief. Need to write you own code or modify the standard published code to adapt insetad of using the reverse feature. Link to comment
Brian H Posted July 22, 2020 Share Posted July 22, 2020 Another option. Would get the original magnetic switch in the early Garage Door Kits. So you didn't have to use the Trigger Reverse function. I had both a NO and NC connection you could choose from. Link to comment
jblackst5000 Posted July 23, 2020 Author Share Posted July 23, 2020 Thanks for the replays and help. I am not using the "Trigger Reverse" mode. I only have Momentary B and LED on TX selected. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.