Jump to content

Fibaro Universal Dimmer 2 - No Dimming Control in ISY?


IPapp

Recommended Posts

In an attempt to control some new wall sconces, I elected to try out a Fibaro Universal Dimmer 2. Simple On and Off is flawless. However, there is a listed dimmer but there is zero range to select other than 0% and 100%. Am I missing something?

Has anyone had any luck with any z-wave dimmers that are wired in, but not actual wall switches? I have a historic home and the thought of modern looking switches being seen is unnerving.

Thanks everyone!

Link to comment
Share on other sites

Just now, IPapp said:

In an attempt to control some new wall sconces, I elected to try out a Fibaro Universal Dimmer 2. Simple On and Off is flawless. However, there is a listed dimmer but there is zero range to select other than 0% and 100%. Am I missing something?

Has anyone had any luck with any z-wave dimmers that are wired in, but not actual wall switches? I have a historic home and the thought of modern looking switches being seen is unnerving.

Thanks everyone!

It would be helpful if you post your Isy firmware and UI

Link to comment
Share on other sites

20 minutes ago, IPapp said:

Oops!

Screenshot 2022-02-13 142140.jpg

Do you have the 300 board (light on back of ISY) or 500 board (no light). If you have the 500 board, Id recommend upgrading to 5.3.4 to see how things work. Most likely, you'll need to set the parameters using the owners manual found on the mfg. website

Link to comment
Share on other sites

  • 1 month later...

@tomho you need to tag @IPapp in your reply for them to get a notification of an update. To tag you have to use the @ sign and then start typing their name and actually select (either arrow down and enter or click the name). It should then show up as the blue "tag" above.

image.png

Hope you get an update on this. What version z-wave controller are you using?

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...